How To Repair Moen 4700 Repair

After years of utilize, a Moen Chateau tub and shower faucet plastic handle will sometimes get grating and potent to pull out. This is relatively easy to remedy.

First, shut off the water supply. Open up the faucet to drain out the water pressure. Then put a rag over the tub drain to catch any parts that drop into the tub.

Using a abrupt edge like a fine-bladed small screwdriver, pry off the handle cap, beingness careful not to mar the plastic finish. Underneath that cap unscrew the handle spiral and pull the handle off.

Pull the chrome tube underneath the handle straight off.

You will find a small copper tab sticking up above the faucet trunk. Grasp it with a pair of needle nose pliers, pull it straight up until the copper forks articulate the faucet torso. Place this keeper in a condom place because it is piece of cake to lose.

Note the end of the contumely shaft that sticks out of the faucet trunk. On the top side of the end of the shaft in that location is a modest flat surface. This surface must confront when you lot put the faucet back together.

A Moen faucet cartridge removal tool is the easiest tool to utilize for pulling the cartridge out of the faucet body, especially if information technology is difficult to remove due to corrosion or debris in the faucet body. Obtain this tool at a local plumbing store; some hardware stores may carry them, or yous may be able to lodge it from http://www.moen.com. Alternatively, y'all can utilise a pair of pliers. Grasp the cease of the stem advisedly, twist, and pull direct out.

One time you lot accept the cartridge removed, audit the faucet body. Clean it out with a toothbrush or have an banana plough the water partially on very briefly to flush out the faucet body.

Audit the faucet cartridge. If it is damaged or has a lot of debris or corrosion, supercede it with a new one. These are normally readily available at hardware stores or home centers.

Lubricate the new cartridge with a good quality stem lubricant. Food grade silicone lubricant works best.

Moen Chateau tub and shower faucet

Install the cartridge with the Moen cartridge removal tool or push it into the faucet body with your fingers, making sure the flat on the finish of the cartridge faces up.

With the cartridge fully seated in the faucet body, install the small copper keeper. Just push information technology downwardly until information technology is fully seated in its slot. You can tell if it is installed properly because you won't be able to install the chrome sleeve or tube unless it is.

Now place the handle over the stem, install the handle screw being careful not to over tighten it. Push the plastic cap in identify, plow on the water, and test your repair.